|Top Previous Next|
The table window contains the main tables from the ECU - ignition, fuel and cam angle, plus other ECU tables such as cranking fuel.
High and Low Speed Cam Tables
Many tables, such as fuel, ignition and cam angle, have a part used for the low speed camshaft and a different part used for the high speed camshaft. Normally these tables are referred to as the 'low speed cam' and 'high speed cam' tables, or just with a 'low' or 'high' suffix. The table window title will normally indication which table is being shown.
Major Table Selection
The main tables may be quickly selected using the toolbar.
The tables are: low speed ignition, high speed ignition, low speed fuel, high speed fuel, low speed cam angle, high speed cam angle.
Cam Angle Selection
For some tables, such as ignition, the ECU has multiple copies for various intake cam angles. In this case, a row of cam angle buttons is shown below the toolbar.
The degree buttons allow the selection of a single cam angle table copy for editing. If 'All' is selected, then the table editing behaviour changes.
It is possible to quickly adjust a selection of cells using two methods:
The quick adjust buttons contain:
For fuel tables the adjustment value is used as a percentage change for add and subtract operations. For other tables it is used as a relative change value.
The selected cells may alter using the special operation buttons:
Right Click Editing
Right clicking on the table allows the current selection to be edited.
Increase Selection, Decrease Selection, Adjust, Interpolate and Smooth change the currently selected values.
Revert to last save resets the table values to the last time the calibration was saved, or to values from when the calibration was loaded, if the calibration was not saved in the current session.
Import from Calibration allows the table to be imported from another calibration.
Live tuning may be enabled on a table by table basis.
For more information see Live Tuning
The right side of the table window contains a 2D or 3D representation of the current table. Mapping points on the 2D graph may be altered by clicking on the rectangles and dragging up or down. On the 3D graph clicking will select an area on the Grid View.
The graph type changed by clicking on the graph type buttons.