Well since I had issues before and everything is supposed to 100% correct. I want to make sure I'm doing step by step everything as it's suppossed to be.
I would like this defined a little better.
4. Create a new calibration from File->New, adjusted only for injector size.
The ecu is a p28... Does that mean I should upload the stock p28 file and just adjust for the injector size and try to start it? Should I adjust for the map sensor as well? It's a 3 bar. I already built a base tune that should be ok for start up and what not.
Should I not use that base tune initially and upload it later or completely remake another tune? Or is it ok to use this for initial upload? It was a tune I downloaded and modified the heck out of to fit my desires.
Your help is much appreciated.....