both red and green light on inside ecu

Spanky · Post by **Spanky** » Thu Dec 15, 2005 6:39 pm

when i start my car, the only light on is green, when i upload it flashes red. when i hit the gas, both lights are on. wtf?

Spanky · Post by **Spanky** » Thu Dec 15, 2005 6:40 pm

car runs and drives ok.

Post by **Spunkster** » Fri Dec 16, 2005 10:27 am

Do you have onboard datalogging enabled?

Spanky · Post by **Spanky** » Sat Dec 17, 2005 12:43 pm

no, but when i show my display, i get like 56000 rpm, crazy numbers. pure tunung installed my s300. first week end after the new year im just gonna drive there and dyno tune. when the car idles everything is fine. as soon as i hit the gas, looneyville.

Post by **Spunkster** » Mon Dec 19, 2005 10:30 am

Make sure you download the latest version of the software, then create a base map by going to file, new. Upload this new base map and if you get any errors uploading, close the program, reopen it and upload the same calibration again. After this turn the key off and back on, then begin datalogging.

Spanky · Post by **Spanky** » Wed Dec 21, 2005 7:16 pm

i let my girlfriend borrow my laptop, until friday. I will do all of this and get back 2 you. thanks alot!