Hondata kpro v4 p1607

K-Series Programmable ECU installation questions / support issues
Post Reply
mikael1995
Posts: 2
Joined: Sat Feb 04, 2023 7:34 pm

Hondata kpro v4 p1607

Post by mikael1995 »

Hello

Bought a used kpro v4 that throws me a p1607 error code and an check engine light . Car was tuned and run 1 day perfectly, at the second day it melted 2 pistons and I am wondering if this code /ECU COULD be a reason for it ? I really can't find an exactly opinion about this error code in the internet some write immobilizer fault some write ECU is defective. I have put the ECU in the other car (exact Model ) and it throws the same error code . My engine is gonna be repaired soon and I was wondering if I can "trust" this ECU again . Any help will be really appreciated as I thrown really thousands of euros in the junk for this engine repair

Thank you
User avatar
Spunkster
Site Admin
Posts: 22745
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Hondata kpro v4 p1607

Post by Spunkster »

What is the serial number that is on the K-Pro board inside the ECU?

What is the ECU part number that is on the white plug inside the ECU?
mikael1995
Posts: 2
Joined: Sat Feb 04, 2023 7:34 pm

Re: Hondata kpro v4 p1607

Post by mikael1995 »

On the chip on hondata white board is writen :

NXP
LPC4078FBD144
S4U191.1
ZSD1502

If this help on any way
Attachments
IMG_20230211_143511.jpg
IMG_20230211_143511.jpg (3.45 MiB) Viewed 666 times
IMG_20230211_143817.jpg
IMG_20230211_143817.jpg (4.58 MiB) Viewed 666 times
IMG_20230211_143831.jpg
IMG_20230211_143831.jpg (3.68 MiB) Viewed 666 times
IMG_20230211_144227.jpg
IMG_20230211_144227.jpg (3.8 MiB) Viewed 666 times
User avatar
Spunkster
Site Admin
Posts: 22745
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Hondata kpro v4 p1607

Post by Spunkster »

You can only use a PRA based calibration with that ECU. All others will give this error.
Post Reply