Hello
Bought a used kpro v4 that throws me a p1607 error code and an check engine light . Car was tuned and run 1 day perfectly, at the second day it melted 2 pistons and I am wondering if this code /ECU COULD be a reason for it ? I really can't find an exactly opinion about this error code in the internet some write immobilizer fault some write ECU is defective. I have put the ECU in the other car (exact Model ) and it throws the same error code . My engine is gonna be repaired soon and I was wondering if I can "trust" this ECU again . Any help will be really appreciated as I thrown really thousands of euros in the junk for this engine repair
Thank you
Hondata kpro v4 p1607
Re: Hondata kpro v4 p1607
What is the serial number that is on the K-Pro board inside the ECU?
What is the ECU part number that is on the white plug inside the ECU?
What is the ECU part number that is on the white plug inside the ECU?
-
- Posts: 2
- Joined: Sat Feb 04, 2023 7:34 pm
Re: Hondata kpro v4 p1607
On the chip on hondata white board is writen :
NXP
LPC4078FBD144
S4U191.1
ZSD1502
If this help on any way
NXP
LPC4078FBD144
S4U191.1
ZSD1502
If this help on any way
- Attachments
-
- IMG_20230211_143511.jpg (3.45 MiB) Viewed 684 times
-
- IMG_20230211_143817.jpg (4.58 MiB) Viewed 684 times
-
- IMG_20230211_143831.jpg (3.68 MiB) Viewed 684 times
-
- IMG_20230211_144227.jpg (3.8 MiB) Viewed 684 times
Re: Hondata kpro v4 p1607
You can only use a PRA based calibration with that ECU. All others will give this error.