Hey looking to see if anyone would have a calibration I could run
K24a1 ( CRV ) stock bottom end 9.6-1
k20a2 head
PRB intake manifold
Type s oil pump
Full intake / 3” inch exhaust
K20a2 injectors (310cc)
Thanks !
Stock K24A1 with K20A2 HEAD
- CalibratEd
- Posts: 1430
- Joined: Fri Feb 07, 2020 3:20 pm
Re: Stock K24A1 with K20A2 HEAD
I can help you out. Can you provide datalogs with wideband data?ryanmaclennan wrote: ↑Wed Jul 27, 2022 4:11 pm Hey looking to see if anyone would have a calibration I could run
K24a1 ( CRV ) stock bottom end 9.6-1
k20a2 head
PRB intake manifold
Type s oil pump
Full intake / 3” inch exhaust
K20a2 injectors (310cc)
Thanks !
-Ed
-
- Posts: 2
- Joined: Thu Apr 20, 2017 12:36 pm
Re: Stock K24A1 with K20A2 HEAD
hey ed , i never logged with kpro before i have with ecutek though sure i can figure it out ! I uploaded the the K24A2 ( 50 degree vtec ) tune from kpro under Type S calibrations , i dont have a wideband atm im running Disabled ( open loop ) with no WOT comp . Im going to order a wideband soon so i can e tune !
- CalibratEd
- Posts: 1430
- Joined: Fri Feb 07, 2020 3:20 pm
Re: Stock K24A1 with K20A2 HEAD
Sounds good. Reach out once you have a wideband connected. I can provide you an etune if you don’t already have a tuner.ryanmaclennan wrote: ↑Sun Aug 07, 2022 7:13 am hey ed , i never logged with kpro before i have with ecutek though sure i can figure it out ! I uploaded the the K24A2 ( 50 degree vtec ) tune from kpro under Type S calibrations , i dont have a wideband atm im running Disabled ( open loop ) with no WOT comp . Im going to order a wideband soon so i can e tune !
-Ed