Looking for remote tuning support - 04 CRV K24 w/ PRB head +

K-Series Programmable ECU Calibration updates / downloads
Post Reply
dfaudiKswap
Posts: 2
Joined: Wed Jun 30, 2021 1:56 am

Looking for remote tuning support - 04 CRV K24 w/ PRB head +

Post by dfaudiKswap »

Ive learned how to navigate the software well, have done tons of datalogging and attempts to smoothen out the fuel maps etc but just running into some other tuning issues and have limited knowledge on how the control logic works and not looking to spend any more time on it.
Looking for someone experienced enough to remote tune fuel/spark/cam angle for fuel economy and daily driving as well as WOT.
I want to get it running buttery smooth as is naturally aspirated with e85 flex sensor and then in the near future doing the turbo kit.

Here's the current setup-

04 CRV w/ kpro-v4
- stock K24 bottom end with 2002 rsx type-s cylinder head PRB
- 50 degree VTC
- 05 TSX cams
- 2002 type-s intake manifold
- stock crv throttle body
- E85 with flex sensor
- stock CRV exhuast manifold (smaller ports than rsx/tsx)
- type-s oil pump/arp head studs
- AWD 6 speed manual with lower final drive, ep3 front lsd

Pm me
-Dave
rge314
Posts: 1
Joined: Wed Mar 30, 2022 6:49 pm

Re: Looking for remote tuning support - 04 CRV K24 w/ PRB head +

Post by rge314 »

Hi, sorry I don't have info for the remote tuning situation but I have few questions about your set up.

1.Are you using the PAA ecu?
1.5. If so do you have to modify in any way your harness?
2.Any modification for the head swap?

My plans are to k24a2 swap a 02 crv mt awd but I can't start until figuring out what ecu to use.

Thanks in advance
Post Reply