v4 Fan problem

K-Series Programmable ECU installation questions / support issues
Post Reply
MatteoHU
Posts: 2
Joined: Fri Feb 21, 2020 5:04 pm

v4 Fan problem

Post by MatteoHU »

Hi,

I have an EP3, 2002, K20A2, RRC Intake, plm header, catback etc.
The car is running on kPro v4, and the issue is: both fans running when not neccessary, and it causes low coolant temperatures. If i start a wide-open pull from 2nd gear, when i shift to 4th my coolant temp is near 70Celsius, and the fans are running. I think the ECU thinks im using A/C, but its mechanical parts from the motor bay are deleted.

Whats the solution? Because my programmer can't establish a good map with changing coolant temperatures over the session..

User avatar
Spunkster
Site Admin
Posts: 18960
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: v4 Fan problem

Post by Spunkster »

Post your calibration and a datalog showing the issue.

MatteoHU
Posts: 2
Joined: Fri Feb 21, 2020 5:04 pm

Re: v4 Fan problem

Post by MatteoHU »

Spunkster wrote:
Fri Feb 21, 2020 5:30 pm
Post your calibration and a datalog showing the issue.
Im just a user, i have the guy 300km away, who did the calibration. I can datalog with the bluetooth app only i guess.

User avatar
Spunkster
Site Admin
Posts: 18960
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: v4 Fan problem

Post by Spunkster »

You can use the KManager software and a laptop to datalog.

Post Reply