Bug/Issue with Highlighting Target Lambda Load

s300 and SManager software questions & answers
Post Reply
creizlein
Posts: 64
Joined: Thu Nov 03, 2016 12:23 pm
Contact:

Bug/Issue with Highlighting Target Lambda Load

Post by creizlein » Sat Mar 17, 2018 2:46 pm

Found a stupid but annoying error on the Target Lambda (Load) fields on the Parameters/Closed Loop Advanced form.
The current state field/cell is no correctly highlighted (as all other tables) , its always stuck and highlight the last one.
On below screenshot you can see that the Target Lambda ETC highlight properly but the Target Lambda Load does not, it stuck on 90kpa when i am currently at only 30kpa (or 330mbar), it also doesn't move while driving.
snap0629.png
snap0629.png (85.1 KiB) Viewed 637 times
Hope your guys can review and fix that for next minor release :)

Post Reply