Won't start cpr

Hondata CPR (Coil Pack Retrofit) support
Post Reply
Phillipjuice
Posts: 1
Joined: Thu Aug 20, 2015 4:12 pm

Won't start cpr

Post by Phillipjuice » Thu Aug 20, 2015 4:30 pm

I hav a 00 si with obd2b wire harness using a jumper harness to obd1.. do you need a distributed in place to run the kit becuse my supplier said no and sold me a cam cap to put in its place.. Now I'm reading the wiring diagram it shows its hooked up and would only make sense becuse it has no other source of reading timing.. Second is I hav no tac wire on the obd2b harness this will not effect anything becuse it's a out put signal correct? just wanted to ask the basic questions that I hav not seen asked b4 thanx

User avatar
Spunkster
Site Admin
Posts: 17940
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Won't start cpr

Post by Spunkster » Thu Aug 20, 2015 4:57 pm

You must have a distributor for this to work. You may have to tap the wire for the tach signal to the CPR harness.

Post Reply