Attached a datalog also.
I searched and someone mentioned to start by adjusting the last 3 columns on the table under the "water temp fuel compensation cracking"
Example:
Is this the correct steps to take?
Mine:
Warm/hot start issue
Warm/hot start issue
I am having warm/hot start issues where the car wants to die (did a couple times) and goes real lean (gauge maxes out) ever since it has been 80-100+ temps out. It does this for about 30 seconds, then idles normal. Cold starts are prefect.
Attached a datalog also.
I searched and someone mentioned to start by adjusting the last 3 columns on the table under the "water temp fuel compensation cracking"
Example:
Is this the correct steps to take?
Mine:
Attached a datalog also.
I searched and someone mentioned to start by adjusting the last 3 columns on the table under the "water temp fuel compensation cracking"
Example:
Is this the correct steps to take?
Mine:
- Attachments
-
- datalog0011.fpdl
- (72.18 KiB) Downloaded 309 times
Last edited by dfw on Tue Jul 03, 2012 10:26 am, edited 2 times in total.
Re: Warm/hot start issue
I would adjust the Air temperature fuel compensation cranking first. The hot weather affects that more than the ECT one.
Re: Warm/hot start issue
How much should I be adding/subtracting at a time?
