Just thought I would share this for anyone who may be interested.
Per the recommendations I gathered on this forum and others, I planned to wire my boost control solenoid on my 2003 Acura RSX Base (K20A3) to the purge valve wiring. Rather than cutting and splicing, I took a gamble on an alternate approach.
Ballenger Motorsports sells two connectors that appeared to be the same size as the RSX purge valve. I purchased pigtail connector CONN-85746 and can confirm that it mates properly with my stock wiring. See attached for confirmation (my retaining clip snapped off long before I tried this, but the connector would fit just fine if it was still there).
Below is a direct link to the one I purchased, for anyone interested.
https://www.bmotorsports.com/shop/produ ... ts_id/1725
Hope this helps someone!
Boost Control Solenoid Connector
Boost Control Solenoid Connector
You do not have the required permissions to view the files attached to this post.
2003 Acura RSX - K20A3
PND ECU with K-Pro v4
PND ECU with K-Pro v4