O2 Sensor

FlashPro questions & answers specific to the 2010 CR-Z (US, Euro & Asia)
Post Reply
Orim
Posts: 2
Joined: Sat Oct 28, 2017 12:58 am

O2 Sensor

Post by Orim »

Hello~

lot of people said they can use hondata flashpro to disable secondary O2 sensor.
i locked flashpro to my car, but not sure which option will do the job

should i disable EGR to make it work? but i through EGR is different than secondary O2 sensor.
i got a JDM CVT 2011 CRZ by the way.

please help.
Thanks
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: O2 Sensor

Post by Hondata »

Parameters -> Closed Loop -> Secondary o2 sensor

There's no need to disable EGR.
Hondata
Orim
Posts: 2
Joined: Sat Oct 28, 2017 12:58 am

Re: O2 Sensor

Post by Orim »

thanks your, i found it now.

also i saw the table list is different between one with other, is it mean some tuning only allowed at certain model?

like 2012 US MT have "Fuel Direct Ratio" but don't have "IMA torque request"
my JP CVT is another way around.

will you able to explain little bit more what "IMA torque request" please
I can understand "RPM", but which perimeter for "Load" are base on?
Because the index are between 0.898 to 1.000. i don't have clues which sensor it reading.

thanks agains
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: O2 Sensor

Post by Hondata »

"Fuel Direct Ratio" is for manifold wall deposit modeling - you only need it if you have a completely different manifold.
"IMA torque request" is the torque the engine requests from the IMA. Increasing at higher rpm will give a little more acceleration. Load index is engine load, but we are unsure of the exact units.
Hondata
Matt Dex
Posts: 47
Joined: Wed Jul 16, 2014 4:05 pm

Re: O2 Sensor

Post by Matt Dex »

Does the Asia crz have this IMA torque request? Where can we find it?
Post Reply