Hyudryu wrote: ↑Mon Dec 18, 2017 7:03 pm
Just wired it up from the Yellow wire of the gauge, instead of the sensor's wire. It's reading properly now thanks a lot.
Now next question, where's the rest of the fields? I noticed the ECT (I'm assuming that's ethanol content) only goes up to 30% does that mean I can only run up to E30? And what exactly is "Slip" It doesn't say anything about slip in the help doc
That table doesnt look right or it's mislabeled ?
To adjust for ethanol content, you would go to your calibration -> ethanol . You will see ethanol ignition multiplier
In the help file, it specifically says that the ignition multiplier is used in conjunction with the ignition compensation table, which looks nothing like what the help file's table looks like. That table is the one that's under the "Ethanol" tab on the calibration
The ethanol content ignition compensation table index is wrong for the 2013-2015 Civic Si. We will fix this for the next release. The flex fuel will work; you just will not be able to edit that table (fully) yet.
The 9psi flex fuel basemap for the new 2016+ Civic (Non-Si), says that upgraded clutch is recommended.
Do you have HP/TQ figures on this? Just wondering how much it makes?
Im still on OEM clutch, so I am guessing i can just take your based map and lower the TC Maximum pressure Ratio to make sure i dont destroy much clutch right??
Notice one detail, that sometimes the FP hangs with the power in Green light all the time.
No action is performed with the datalog button... this happen in a FN2.
This issue is possible do to turn the engine off while in datalog.
To return to normal operation, disconnecting and connecting would solve.
myuser wrote: ↑Fri Dec 29, 2017 3:01 pm
Notice one detail, that sometimes the FP hangs with the power in Green light all the time.
No action is performed with the datalog button... this happen in a FN2.
This issue is possible do to turn the engine off while in datalog.
To return to normal operation, disconnecting and connecting would solve.
I had that happen a lot when i had a lot of datalog stored in my FlashPro. Once i deleted them , the hang up went away
myuser wrote: ↑Fri Dec 29, 2017 3:01 pm
Notice one detail, that sometimes the FP hangs with the power in Green light all the time.
No action is performed with the datalog button... this happen in a FN2.
This issue is possible do to turn the engine off while in datalog.
To return to normal operation, disconnecting and connecting would solve.
I had that happen a lot when i had a lot of datalog stored in my FlashPro. Once i deleted them , the hang up went away
The recent hang was with 9 recordings, with total memory free of 67%.
In previous versions, the datalog button was was always available.
myuser wrote: ↑Fri Dec 29, 2017 3:01 pm
Notice one detail, that sometimes the FP hangs with the power in Green light all the time.
No action is performed with the datalog button... this happen in a FN2.
This issue is possible do to turn the engine off while in datalog.
To return to normal operation, disconnecting and connecting would solve.
I had that happen a lot when i had a lot of datalog stored in my FlashPro. Once i deleted them , the hang up went away
The recent hang was with 9 recordings, with total memory free of 67%.
In previous versions, the datalog button was was always available.
Yup, It started to crash with this version for me too. I was at 60% full but once I cleared up some space. It went back to normal for me.