Hondata s300 red led flashing fast
Re: Hondata s300 red led flashing fast
Since you purchased the s300, has it ever worked?
Re: Hondata s300 red led flashing fast
No not yet. The mount a week ago
Re: Hondata s300 red led flashing fast
The Ecu works. The pc detects it. I can upload calibrations. I have both green LEDs on. But the smanager does not read sensors. The engine starts, the car moves. But it does not exceed 2500rpm and goes off in idle.
Re: Hondata s300 red led flashing fast
Where did you purchase this s300 from?
Re: Hondata s300 red led flashing fast
A US seller sent me to Spain
Re: Hondata s300 red led flashing fast
Who was the seller? We need to trace the S300 back to us.
Hondata
Re: Hondata s300 red led flashing fast
Already solved. I just had to disable two injector errors and Baro
Re: Hondata s300 red led flashing fast
I was not a store seller I was a person who bought it and I did not get to use it
Re: Hondata s300 red led flashing fast
Thank you for your attention. Good service
-
- Posts: 135
- Joined: Mon May 12, 2014 4:13 pm
- Location: Victoria BC
- Contact:
Re: Hondata s300 red led flashing fast
I just finished having an issue like this, My red light was flashing and no solid green light at the USB connector, what I found was the main board( Green Honda ECU) needs to be clean of all flux used during the socketing process as voltages will bleed to other connectors and cause very erratic behaviors or not even work at all. Also I pulled both hondata and the ecu(green board) out of my aluminum case and tested continuity from the back of the green board to the top of the white(hondata s300 v3) for all the 14 header pins to make sure there was a solid connection. also on the second rail of 14 headers and the 4 pin datalogger header. If issues persists replace the stock ecu's capacitors and again clean the board of all flux or (soldering assist material)
Let's not make assumptions, please leave as much detail as possible!