Hondata s300 red led flashing fast
Hondata s300 red led flashing fast
My English is bad, I will use a translator. Install my honda s300 v3 in my Honda Prelude SH. Smanager does not read the engine parameters in real time. A red light flashes quickly, not before. When I connect to the PC without connecting to the vehicle also red light that blinks. What can be the motive?
Re: Hondata s300 red led flashing fast
The red light no longer appears but if I have the revolutions limited to 2500rpm. I have inspected the harness and it looks like it is perfect. The welds are perfect. I cut the j12. J4 I have not cut it because I read that it is not relevant. So I do not know what to do anymore.
Re: Hondata s300 red led flashing fast
Is this in a rectangular ECU or a square ECU?
Re: Hondata s300 red led flashing fast
37820-p28-g02 AWR
Is rectangular
Is rectangular
Re: Hondata s300 red led flashing fast
Have you enabled on-board datalogging?
Re: Hondata s300 red led flashing fast
I'll check in a moment
Re: Hondata s300 red led flashing fast
Is not activated. The light only blinks when I connect the pc, I suppose that's why. My problem now is that it does not rise from 2500rpm and in idle it goes off
Re: Hondata s300 red led flashing fast
so you are saying the red light stops flashing when it idles?
Re: Hondata s300 red led flashing fast
The red light blinks only when the PC is connected. Now I have the problem of protection mode
Re: Hondata s300 red led flashing fast
What is the serial number that is on the s300 board inside the ECU?
From Help, About, what is the version of software you are using?
From Help, About, what is the version of software you are using?
Re: Hondata s300 red led flashing fast
Serial number Hondata: 39248
Serial number ECU: 37820-p28-g02
Hardware: version 3
Firmware: version 8
Software: version 2.5.5
Serial number ECU: 37820-p28-g02
Hardware: version 3
Firmware: version 8
Software: version 2.5.5
Re: Hondata s300 red led flashing fast
Have you uploaded the calibration to the ECU using this version of software? Are you able to datalog?
Re: Hondata s300 red led flashing fast
I have uploaded the calibration with this version on two different PCs. I can not do datalog because it does not read the sensors. Even if it starts, it's strange
Re: Hondata s300 red led flashing fast
Has the s300 ever worked on this ECU?
Where are you located?
Where are you located?
Re: Hondata s300 red led flashing fast
I dont understand that question. I live in Cadiz, Spain