PWM Output
PWM Output
I know that has at least 1 PWM out put since Flash Pro will allow me to control boost. Is there a second controllable output?
Re: PWM Output
Ouch. If I were to go to drive by cable, could I use its output as a second pwm output?
Re: PWM Output
Hondata where is the ECU pin of boost control solenoid for TSX?
http://www.hondata.com/help/flashpro/in ... meters.htm
http://www.hondata.com/help/flashpro/in ... meters.htm
Cr-v RD8+K24A2turbo+Kpro V4 prb+NPR3/6Speed+ТС+ HFS4 v3.2.
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper
Re: PWM Output
Thanks guys, it would be nice to add this info to flashpro help , with pics .
Re: PWM Output
ThanksHondata wrote:Pin B16, the same as the S2000.
Cr-v RD8+K24A2turbo+Kpro V4 prb+NPR3/6Speed+ТС+ HFS4 v3.2.
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper
Re: PWM Output
We hope to see at new version of flash manager all ours wishes.Hondata wrote:Yes, it was in the help file already, but for the next release version.
Cr-v RD8+K24A2turbo+Kpro V4 prb+NPR3/6Speed+ТС+ HFS4 v3.2.
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper