skunk2 stage 1 with reflash
skunk2 stage 1 with reflash
hi, i will be putting in some skunk2 stage 1s in to my 06 civic si, was wondering if the stage 1s would be too aggressive for the basic reflash for the 06 civic si? or do u think the reflash would be sufficient ? i know the reflash is specifically for vehicles w/ i,h,e (basic bolt ons). any suggestion would be appreciated.
piggyback like system
i heard there may be a piggyback style system from hondata for the 06 and up civic si instead of a kpro system. is this true?
hey guys, here are my dyno sheets for my 06 civic si. i was thinking about how the reflash doesn't do anything for a/f adjustments. However, with the reflash, do u guys think it'll smoothen out my richness in the midrange? the reflash will kick the vtec around where i start to run rich so i was thinking with vtec there, the extra air flow should make my a/f more stoichiometric there since im a bit rich around that midrange(assuming the ecu doesn't send more fuel when it reads this extra air flow). what do u guys think? the ecu didn't send in too much fuel when i was in vtec being that my a/f was around 13/1 until the stock redline. my mods are: cai, rh, exh, no reflash.
- Attachments
-
- si dyno 1.jpg (237.92 KiB) Viewed 4936 times
-
- si dyno 2.jpg (231.47 KiB) Viewed 4936 times
Hi guys,
i m french and my car is civic type r fn2 k20z4. Here my mods: hondata reflash ecu, catback, cpl race header, cai injen, rrc intake manifold, 70mm throttle body dbw, exedy stage 2 clutch and flywheel, skunk2 fuel rail...
i want to buy skunk2 stage 1 cams !! Can you tell me if it s compatible with my reflash ecu ?
thanks
i m french and my car is civic type r fn2 k20z4. Here my mods: hondata reflash ecu, catback, cpl race header, cai injen, rrc intake manifold, 70mm throttle body dbw, exedy stage 2 clutch and flywheel, skunk2 fuel rail...
i want to buy skunk2 stage 1 cams !! Can you tell me if it s compatible with my reflash ecu ?
thanks