I'm trying to set the nitrous 1 control up to run a shift light bulb.
One side of the bulb (1057) goes to 12v, other to E connector (all the listed connections)
Fuel 0, retard 0, engine speed 3500- 8000 (launch RPM), load 0- max bar, throttle 0-100, vss 0-158 (internal vss signal).
Watching the KPro sensors I can see nirous 1 armed, and at 3500 RPM nitrous 1 turns on. Darn light bulb doesn't light.
ECU E connector pin at 12v all the time.
The VSS signal from my Toyota transmissioin is not reliable.
HELP!!!
Del Long
Nitrous control for shift light
-
- Posts: 248
- Joined: Wed May 17, 2006 9:49 am
-
- Posts: 248
- Joined: Wed May 17, 2006 9:49 am