20+ K.Count , Looking to get some input

FlashPro questions & answers specific to the 2007-2008 US TSX
Post Reply
timxchan
Posts: 1
Joined: Tue Oct 01, 2024 7:43 pm

20+ K.Count , Looking to get some input

Post by timxchan »

Hello, fairly new to Hondata but I've been doing some homework about tuning and experimenting(while trying not to make the car blow up), but I've been making a basemap and it feels good but as I do pulls I notice the Knock counter raises sometimes by 10 in a single pull. Haven't touched the ignition low or high but I am thinking that it is contributing to the knocks. Still learning to read(datalogs) and identify what is causing it but here is a provided datalog of a quick cruise and 3rd gear pull along with the calibration I was using ..

First pull I was not able to get to redline due to "obstacles" but K.count was 12, 7 in #1 and 5 in #2.
Second pull where I got up to 7.2k K.count came out to 15 adding 2 to #1 and 1 to #2.
By the end I was at 25 K.count
Pretty much stuck on where to go from here to find the knocks. Thanks :p

09 K24Z3 TSX A/T w/ I/H/E if that helps
Attachments
cruising and 3rd gear pull.fpdl
(1.8 MiB) Downloaded 42 times
BM2.fpcal
(20.02 KiB) Downloaded 43 times
Patilgk1999
Posts: 4
Joined: Thu May 28, 2020 5:11 pm

Re: 20+ K.Count , Looking to get some input

Post by Patilgk1999 »

I am by no means an expert on the tuning side, but from personal experience I would check to make sure everything on the mechanical side is good frist. Make sure your sensor is good. On the tuning side you can get knock when running a bit lean so I could look into that.
Post Reply