Need basemap so i can drive to dyno

FlashPro questions & answers specific to the 2006-2011 Americas Civic Si
Post Reply
Rambo
Posts: 3
Joined: Sun Jun 12, 2022 4:39 pm

Need basemap so i can drive to dyno

Post by Rambo »

I currently have a full race exhaust
Hybrid racing intake
And skunk2 header
Also have a thermal throttle body gasket not sure if im going to install that one
My elevation is about 550’
Thx in advance
Rambo
Posts: 3
Joined: Sun Jun 12, 2022 4:39 pm

Re: Need basemap so i can drive to dyno

Post by Rambo »

Forgot to mention its a 2008 fg2 with almost 190k miles
Rambo
Posts: 3
Joined: Sun Jun 12, 2022 4:39 pm

Re: Need basemap so i can drive to dyno

Post by Rambo »

I also have hasport rear mount installed
Jvasqu28
Posts: 11
Joined: Sat May 21, 2022 3:42 pm

Re: Need basemap so i can drive to dyno

Post by Jvasqu28 »

I’m assuming you have hondata and there is a basemap on there you could flash, that is for intake/ exhaust/header. That map should be fine for you to drive on. Honestly You'll probably be fine to drive to the dyno with the stock tune. Either way you should be ok since it’s just to the dyno.

Some people go full bolt on without a tune even though it’s counterintuitive to do so. A tune helps maximize performance gains and fine tune drivability/AFR’s.
Post Reply