TC with other management system
Re: TC with other management system
ECUs will need an analog input / ignition retard table to use the Traction Control module.
Re: TC with other management system
To clarify, the AEM unit is the one built for the 06+ S2000 by Science of Speed. Here are the inputs supported.
INPUTS / OUTPUTS SUPPORTED
4 independent sequential injectors
4 independent ignition coils
3 available analog inputs (fuel pressure, oil pressure, boost position switch, traction control switch, etc)
2 available switched inputs (FlexFuel, traction control pulse converter input, etc)
1 available temperature input (oil temperature)
4 switched ground (boost control, traction control status lamp, traction control slip lamp, etc)
MIL (malfunction indicator lamp, aka "check engine lamp") through optional CAN Translator
It lists this feature which leads me to believe it can work with your unit.
"Advanced configurable traction control system (with optional signal converter)." Normally it would use the speed sensor in the transmission. Unfortunately we changed to a Quaife sequential transmission and lost that sensor.
INPUTS / OUTPUTS SUPPORTED
4 independent sequential injectors
4 independent ignition coils
3 available analog inputs (fuel pressure, oil pressure, boost position switch, traction control switch, etc)
2 available switched inputs (FlexFuel, traction control pulse converter input, etc)
1 available temperature input (oil temperature)
4 switched ground (boost control, traction control status lamp, traction control slip lamp, etc)
MIL (malfunction indicator lamp, aka "check engine lamp") through optional CAN Translator
It lists this feature which leads me to believe it can work with your unit.
"Advanced configurable traction control system (with optional signal converter)." Normally it would use the speed sensor in the transmission. Unfortunately we changed to a Quaife sequential transmission and lost that sensor.
Re: TC with other management system
I would suggest you discuss this with Science of Speed as they will know exactly what that AEM unit can and can't do.
Re: TC with other management system
I need to know what sort of output your T/C is going to provide to signal the ECU that there is wheel spin.
5v or variable voltage etc... It looks like the orange wire is the only signal wire on your unit.
Thanks for your help
5v or variable voltage etc... It looks like the orange wire is the only signal wire on your unit.
Thanks for your help
Re: TC with other management system
It is 0-5 volt analog signal.
Re: TC with other management system
So the T/C unit will vary the 0-5v signal depending on slip? Thanks
Re: TC with other management system
correct.