Build B16A Turbo

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Sneaky_84
Posts: 7
Joined: Wed Oct 19, 2016 5:48 pm

Build B16A Turbo

Post by Sneaky_84 »

whats up guy i need an basemap to drive my car to the dyno.
my built is:
-JDM B16A CSS block
-JDM B16 head
-Supertecht valve train (flat valve)
-Skunk2 pro1 cams
-Edelbrock intake with 72mm throttlebody
-RC1200cc injector
-aeromotive regulator
-golden eagle fuelrail
-Ktuned 4 bar map sensor
-Hondata coil on plugs
-Arias piston 81.5mm (10.5:1)
-Skunk2 rods
-GSR tranny with competicion clutch stage 5
-GT35 turbo with 38mm wastegate 11psi spring
-2" hotside and 3" coldside
-Hondata s300v2 with bbg
-walbro 450lph pump
-8an feed lines with high flow filter

let me know what you have.

thanks,
J.Donato
payam_fox
Posts: 19
Joined: Sat Jun 15, 2019 4:34 pm

Re: Build B16A Turbo

Post by payam_fox »

did you find a map ? i have attached one from my b16 built turbo low comp
Attachments
gooood dont touch.skl
(47.47 KiB) Downloaded 381 times
Bashy1992
Posts: 7
Joined: Sat Jan 11, 2020 2:24 pm

Re: Build B16A Turbo

Post by Bashy1992 »

payam_fox wrote: Sat Jun 15, 2019 4:45 pm did you find a map ? i have attached one from my b16 built turbo low comp
Whats the spec on ur injectors and turbo and boost cut and stuff?
Post Reply