Unable to set target lambda parameters on version 2.6.9.0
Unable to set target lambda parameters on version 2.6.9.0
Installed latest version today and I noticed I'm unable to set lambda parameters base on engine load. I'm on windows 10
Re: Unable to set target lambda parameters on version 2.6.9.0
Since the update to 2.7 I got a couple of problems.
I am to connect to the ECU and download the basemap. But when I attempt to datalog it gives an error and automatically closes the application.
I also notice that if I don't download the basemap on the ecu it connects to datalog and when I attempt to download the basemap while datalogged it gives the same error
Also this maybe minor but on column 10 on the fuel map no matter if I change it to vacuum or psi its value is not right.
Re: Unable to set target lambda parameters on version 2.6.9.0
What s300 do you have, and what are you doing then you 'download the basemap'?
Hondata
Re: Unable to set target lambda parameters on version 2.6.9.0
Ok, I've got it. You need to go into settings and set the datalog overlay sensor to something. I think the lambda sensor might still be a problem for you (if it does not say 'AF'), but I'll make a new release shortly that will take care of it.
Hondata
Re: Unable to set target lambda parameters on version 2.6.9.0
On version 2.6.8 I didn't have this problem