Hondata CPR (Coil Pack Retrofit) support
do you have a diagram you can share on how you wired up the relay to power the Hondata CPR box?
A diagram is not needed. Wire the switch wire for the relays to a power source that stays on while cranking. The main power wire should connect to the battery or strong power source.
From what you're saying it sounds like I will need to use two relays, one to power the CPR box and another to power the coils? Does this look about right? I know you said to "hell with directions" lol but the ground source for the relay for the CPR box... I should keep that as close to the ECU as possible?
- CPR with Relays.png (105.03 KiB) Viewed 760 times