Found a other problem.
I use a 4 Bar Hondata MAP Sensor. Set it in the Calibration, Sensors to Hondata 4 Bar.
Wanted to change the Load Index, to match the Sensor.
In the Fuel and ignition Tables i cannot change the Load Index (the dropdown menu is greyed out).
I only can change it in the CAM Angle Tables, but the scaler does not affect any other table.
Software is Flashpro 3.0.9.0
Calibration is Accord-09-Europe-MT
cannot edit Load Index in fuel/Ign. etc. only in CAM
-
- Posts: 17
- Joined: Mon Apr 02, 2018 2:03 pm
Re: cannot edit Load Index in fuel/Ign. etc. only in CAM
The Accord tables only go to 240 kPa.
Hondata
-
- Posts: 17
- Joined: Mon Apr 02, 2018 2:03 pm
Re: cannot edit Load Index in fuel/Ign. etc. only in CAM
Really? I didn't see this information anywhere?
What's the reason for this?
What's the reason for this?
-
- Posts: 17
- Joined: Mon Apr 02, 2018 2:03 pm
Re: cannot edit Load Index in fuel/Ign. etc. only in CAM
Please let me add one more question: Regardless from that the tables goes not higher than 240kpa, why i'm not able to edit the load index at all?
Re: cannot edit Load Index in fuel/Ign. etc. only in CAM
Sometimes the indexes are shared between multiple tables and cannot be changed with altering all the tables that use the index.
Hondata