Hondata Mode not working in 3.2.9
Re: Hondata Mode not working in 3.2.9
We have tested this repeatedly and have not been able to find any issues with how the Hondata mode works.
Re: Hondata Mode not working in 3.2.9
Spunkster,
Agreed, ...and after I converted all of the Bar values over to PSIg I can see that my datalogs are exactly where they should to be. So, was there a problem with the old +6 PSI tune? Was it overboosting? Was the cylinder fill knock air limit different? I noticed the +7 PIS boost is gone from the calibrations. Why? Finally, there is a warning as to clutch slippage with +9 psi, at what gear and or RPM? I assume the faster you are going, the less likely the clutch is to slip. This can now be corrected with boost by gear. Thoughts?
Agreed, ...and after I converted all of the Bar values over to PSIg I can see that my datalogs are exactly where they should to be. So, was there a problem with the old +6 PSI tune? Was it overboosting? Was the cylinder fill knock air limit different? I noticed the +7 PIS boost is gone from the calibrations. Why? Finally, there is a warning as to clutch slippage with +9 psi, at what gear and or RPM? I assume the faster you are going, the less likely the clutch is to slip. This can now be corrected with boost by gear. Thoughts?
Re: Hondata Mode not working in 3.2.9
There have not been any problems with the calibrations. There never was a +7 PSI calibration. The warning applies to using the +9PSi calibration. It really depends on how you drive the car and how hard on the clutch you are and have been.