Page 1 of 1
Need calibration
Posted: Sun May 13, 2018 2:28 pm
by thomcouts33
If anyone can do calibration for me, just mp me. Just bolt-on:
-RV6 V3 precats delete
-Manifold intake/Throttle body 3.7l
-P2R Throttle body spacer
-P2R Intake manifold spacer
-P2R EGR delete
-J-Pipe ATLP V2-R
-Cold air intake custom 4inch
-Stock exhaust
+
4 codes
+
rev haaaaaang
Need help! Thank you!
Re: Need calibration
Posted: Sat Apr 25, 2020 10:17 pm
by NIGHTHAWK_BP
did you ever get help with that? im dealing with the same issues.i have about the same mods just pnp runners mani and tb
Re: Need calibration
Posted: Sat Apr 25, 2020 10:17 pm
by NIGHTHAWK_BP
and catback exhaust
Re: Need calibration
Posted: Sun Apr 26, 2020 12:42 am
by EFICU
NIGHTHAWK_BP wrote: ↑Sat Apr 25, 2020 10:17 pm
and catback exhaust
What issues are you having?
Can you post a decent length datalog and the calibration you're driving on?
Re: Need calibration
Posted: Mon Jul 06, 2020 11:04 am
by larrymenze
I hope u got ur issues resolved. Im have similar issues. I cant do a new calibration with the mods I done to my 3.2. And now I having problems communicating with any hondata techs.
Re: Need calibration
Posted: Fri Sep 04, 2020 5:26 am
by larrymenze
finally got the running issue resolved after installing the 3rd TB. Runs well! when trying to install a new calibration Im having issues. I think I installed a base cal ok. When FP is connected properly to vech all the ck marks at the bottom of screen be green? Cant seem to set up and install a calibration with the mods I have.
Re: Need calibration
Posted: Fri Sep 04, 2020 10:10 am
by Spunkster
start a thread with complete details of the issues you are having.