2007 Acura TL Type-S 6MT FlashPro Problem
Posted: Sun May 19, 2013 10:33 am
So basically I am going to be using VitTuned for my FlashPro tune on my 07 Type-S 6MT.
Mods consist of AEM V2, RV6 PCDs, RV6 JPipe, 3rd cat delete, XLR8 Catback, 3.7L manifold port matched to PnP runners, ZDX Throttle Body, XLR8 75a engine mounts, clutch masters stage 3 kevlar clutch etc.
So I got the tune on the car and launch control was set to 5000 rpm, and bounce was at 4700 I think. But anyways launch control worked in 1st gear, but when I took off (didnt launch it either) and I got to 5000 rpm in 1st it saw that lunch control as a rev limiter. 2nd, 3rd and 4th all did the same thing, would rev limit at that launch control point, and not the 6900 redline that the car has. I had to set launch control at 6900 rpm so that I could actually drive the car normally.
Why is the FlashPro doing this? Any insight as to why this is happened would greatly appreciated.
Also another issue I am having is severe knock in cylinder 3. With or without the tune, its showing knock. However the knock counter does not continuously tally the knock, it keeps fluctuating up and down. The count should just go up 1, 2, 3, 4 etc. However its jumping all around with no rhyme or reason. Anyone ever experience this?
Mods consist of AEM V2, RV6 PCDs, RV6 JPipe, 3rd cat delete, XLR8 Catback, 3.7L manifold port matched to PnP runners, ZDX Throttle Body, XLR8 75a engine mounts, clutch masters stage 3 kevlar clutch etc.
So I got the tune on the car and launch control was set to 5000 rpm, and bounce was at 4700 I think. But anyways launch control worked in 1st gear, but when I took off (didnt launch it either) and I got to 5000 rpm in 1st it saw that lunch control as a rev limiter. 2nd, 3rd and 4th all did the same thing, would rev limit at that launch control point, and not the 6900 redline that the car has. I had to set launch control at 6900 rpm so that I could actually drive the car normally.
Why is the FlashPro doing this? Any insight as to why this is happened would greatly appreciated.
Also another issue I am having is severe knock in cylinder 3. With or without the tune, its showing knock. However the knock counter does not continuously tally the knock, it keeps fluctuating up and down. The count should just go up 1, 2, 3, 4 etc. However its jumping all around with no rhyme or reason. Anyone ever experience this?