Can't edit columns/rows for DBW in flashpro software

2007-2008 Fit
Post Reply
kraftwerksfit
Posts: 23
Joined: Wed Jun 19, 2013 1:27 pm

Can't edit columns/rows for DBW in flashpro software

Post by kraftwerksfit »

Hello, can we get an update to be able to edit/make use of the redundant columns for more DBW resolution? And edit the rows for higher than 7k RPM?
Attachments
Target throttle plate cant edit.jpg
Target throttle plate cant edit.jpg (380.45 KiB) Viewed 2825 times
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Can't edit columns/rows for DBW in flashpro software

Post by Hondata »

Sorry, no. For legal reasons we don't allow the indexes to be altered.
Hondata
kraftwerksfit
Posts: 23
Joined: Wed Jun 19, 2013 1:27 pm

Re: Can't edit columns/rows for DBW in flashpro software

Post by kraftwerksfit »

So what would happen with higher RPM? reference 7k row?
kraftwerksfit
Posts: 23
Joined: Wed Jun 19, 2013 1:27 pm

Re: Can't edit columns/rows for DBW in flashpro software

Post by kraftwerksfit »

Hondata wrote: Fri Jun 11, 2021 1:13 pm Sorry, no. For legal reasons we don't allow the indexes to be altered.
I totally understand from a legal standpoint why you would want to lock these columns/rows. My issue/questions are I have a custom fabricated extremely short and larger dia runner intake manifold with 5mm lager (R18) TB for the time being over stock, The added 3 columns of resolution may afford smoother off idle/low RPM drivability. I have a J35 (62mm I.D.) TB which I was planning to run but the low speed drivability will become worse I fear. Additionally the Rotrex C15-60 with the current sized pulley and crank pulley I calculated I can spin to 7200 RPM (Rotrex maximum impeller speed) in my application. Currently I have rev limiter set to 6900 RPM. I will need to upgrade the MAP sensor to Hondata 4BAR but want to make sure as far as the flashpro software goes, I won't run into issues in the tables to rev to 7200 RPM?

Logically the software will reference the 7000 RPM row for any RPM above it, just looking for clarification from Hondata.
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Can't edit columns/rows for DBW in flashpro software

Post by Spunkster »

It will use the last column until you hit the rev limit.
kraftwerksfit
Posts: 23
Joined: Wed Jun 19, 2013 1:27 pm

Re: Can't edit columns/rows for DBW in flashpro software

Post by kraftwerksfit »

Spunkster wrote: Fri Jun 11, 2021 3:42 pm It will use the last column until you hit the rev limit.
Thank you that is what I figured.
Post Reply