Page 1 of 1

Flashpro won't recognize my ECU after engine removal

Posted: Mon Oct 15, 2018 8:05 pm
by Devmail
Hello,

I have been using flashpro successfully for a few weeks. Then I removed my engine and now flashpro can't see the ECU. I can't flash my ecu back to stock to unlock the flashpro either. I tried updating flashpro manager and the sub drivers with no luck. It worked fine before I removed the Engine...please help. It did recognize that my battery was getting low so I recharged the car battery and it is still not working.

Re: Flashpro won't recognize my ECU after engine removal

Posted: Tue Oct 16, 2018 10:05 am
by Spunkster
You will have to connect the grounds in the engine bay for it to see the ECU.

Re: Flashpro won't recognize my ECU after engine removal

Posted: Tue Oct 16, 2018 5:49 pm
by Devmail
I'll give it a try, thank you!

Re: Flashpro won't recognize my ECU after engine removal

Posted: Wed Oct 17, 2018 6:25 pm
by Devmail
Spunkster wrote: Tue Oct 16, 2018 10:05 am You will have to connect the grounds in the engine bay for it to see the ECU.
And hook up the grounds from the engine back to chassis, correct?

Re: Flashpro won't recognize my ECU after engine removal

Posted: Thu Oct 18, 2018 10:12 am
by Spunkster
They must be grounded at the battery

Re: Flashpro won't recognize my ECU after engine removal

Posted: Fri Oct 19, 2018 5:08 am
by Devmail
Turns out it was my fuel pump relay. Interesting...