Scalar and offset calibrations

2007-2008 Fit
Post Reply
trinimadness
Posts: 4
Joined: Fri Jun 14, 2013 3:30 pm

Scalar and offset calibrations

Post by trinimadness » Mon Sep 09, 2013 11:05 am

I am new to this forum. Could someone please help me with finding the scalar and offset for a map sensor. The information is below but I do not have a clue where to start with this information. It is a 3 bar map sensor so I believe this is the correct information below as when I try to upload the entire sheet with all the different sensors it does not load correctly.

30-2130-50
0-50 PSIa
-14.70
-11.58
-8.45
-5.33
-2.20
0.93
4.05
7.18
10.30
13.43
16.55
19.68
22.80
25.93
29.05
32.18
35.30

User avatar
Spunkster
Site Admin
Posts: 17772
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Scalar and offset calibrations

Post by Spunkster » Mon Sep 09, 2013 11:33 am

This is not anoption for a Fit with FlashPro.

Why are you asking this qustion in different forums with different vehicle types?

trinimadness
Posts: 4
Joined: Fri Jun 14, 2013 3:30 pm

Re: Scalar and offset calibrations

Post by trinimadness » Tue Sep 10, 2013 9:29 am

It is for inputting information into a Hondata ECU. It is quite obvious i am new to these forums so could you please direct me where to ask this question.

User avatar
Spunkster
Site Admin
Posts: 17772
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Scalar and offset calibrations

Post by Spunkster » Tue Sep 10, 2013 10:03 am

Post in the section of what Hondata system you actually have.

Post Reply