Page 1 of 1

Traction Control Compatible with R18A1

Posted: Mon Oct 08, 2012 6:40 pm
by 420Coupe
I am curious to see if your Traction Control is compatible with the R18A1 platform as I see it only requires speed sensors and not an ABS system.

If not would be much appreciated if that could be incorporated with BBG, a full speed density compatibility and the ability to adjust Final drive so the speedometer will still read correctly. Again it would be much appreciated Derek ! Thanks again buddy!

Re: Traction Control Compatible with R18A1

Posted: Tue Oct 09, 2012 10:19 am
by Hondata
It is the other way around - your question is whether the R18 FlashPro supports Traction Control.

The R18 ECU does not have any inputs which can be used for Traction Control.

Re: Traction Control Compatible with R18A1

Posted: Wed Oct 10, 2012 6:28 pm
by 420Coupe
Hondata wrote:It is the other way around - your question is whether the R18 FlashPro supports Traction Control.

The R18 ECU does not have any inputs which can be used for Traction Control.
Any way to add the required sensors/ cables and connect them to the pin so there exist an input ?

Is this the same reason BBG with a solenoid will not work ?


-Thanks

Re: Traction Control Compatible with R18A1

Posted: Tue Oct 03, 2017 8:20 am
by BEKA-BEKA
Hondata wrote:
Tue Oct 09, 2012 10:19 am
It is the other way around - your question is whether the R18 FlashPro supports Traction Control.

The R18 ECU does not have any inputs which can be used for Traction Control.
Sorry to bring this post alive, to summarize, the R18 has abs module and wheel speed sensors available for the traction control installation, it is just the R18 ECU doesn't have any spare analog input to be used for the TC slip signal, is this right?