Where do retrofitted ABS sensor wires need to go?
Posted: Thu Jun 13, 2019 1:04 pm
Hi,
I dont think this has been asked, i have checked a lot of threads on here for similar questions.
If i were to retrofit ABS sensors on to my car, where do i send the wires? as i wont have the control unit and my loom is 100% custom, so there is no loom to plug them in to etc. Is it simply a case of power from the TC module and a ground to chassis?
I have EK9 front and rear hubs, so OEM sensors will bolt straight on, but after that.....what would i need to know? (Assuming i were to purchase the Hondata TC module).
Thanks,
Neil
I dont think this has been asked, i have checked a lot of threads on here for similar questions.
If i were to retrofit ABS sensors on to my car, where do i send the wires? as i wont have the control unit and my loom is 100% custom, so there is no loom to plug them in to etc. Is it simply a case of power from the TC module and a ground to chassis?
I have EK9 front and rear hubs, so OEM sensors will bolt straight on, but after that.....what would i need to know? (Assuming i were to purchase the Hondata TC module).
Thanks,
Neil