Flashpro does not get power from OBD2 Port

FlashPro questions & answers specific to the 2007-2008 US TSX
Post Reply
rayzian
Posts: 2
Joined: Wed Aug 12, 2020 5:35 pm

Flashpro does not get power from OBD2 Port

Post by rayzian »

Hi guys, just got flashpro and was having a lot of fun playing with calibrations. I've flashed the ECU maybe about 3 times so far, but now when i plug in Flashpro to the obd2 port with key to ON, flashpro does not power on.

I can plug flashpro onto my computer and it gets power (power & usb light on) I can even upload new calibrations to it without issue.

I also have a FIXD obd2 reader that works no problem in the OBD2 port.

But when I plug flashpro in, the power light works for couple seconds then turns off, datalog and power then continue to randomly flash.

Is my flashpro unit faulty? Any ideas?

Serial # FP-TSX-US-90913
rayzian
Posts: 2
Joined: Wed Aug 12, 2020 5:35 pm

Re: Flashpro does not get power from OBD2 Port

Post by rayzian »

found this:

viewtopic.php?f=37&t=22989&p=107017&hil ... cu#p107017

ended up being the exact same issue, white CAN wire was pushed out by flashpro connector
Post Reply