Page 1 of 1

Idle Learn

Posted: Tue Jun 14, 2016 1:52 pm
by dinoc
While doing an Idle Relearn I've noticed in HDS (Honda Diagnostic System tool) that Idle Learn Parameter always stays in "Learning" it never goes to Completed state.

Is this related to Flashpro firmware or tuning or something else?
(I'm using a Flashpro map on CL9 MT 2007.)

Re: Idle Learn

Posted: Wed Jun 15, 2016 8:45 am
by Hondata
We do not change any of the idle learn parameters / behavior.

Re: Idle Learn

Posted: Fri Jun 17, 2016 7:58 am
by dinoc
This one related probably to this one? ... 652#p87652