another question, i may be overthinking this, but in the "flashpro help" it says to set the activation boost pressure slightly over atmospheric pressure which is 14.7psi at sea level.
I want my solenoid to kick in around 5psi of boost. Should I set the boost activation pressure to 5psi or 14.7psi? Thanks.
boost activation question
Re: boost activation question
It would be 5 psi as PSI cannot measure below atmospheric pressure.
-
- Posts: 18
- Joined: Wed Jul 09, 2014 9:07 am
Re: boost activation question
i was never good at chemistry...math...whatever this question would fall under haha. thanks!