Hey guys,
I know this issue has been raised before about the ID1000 Injectors - sizing and voltage offset (opening/dead times) that are published by ID but do not necessarily react the way they should in the FlashPro manager.
Can anyone provide some voltage offset data and injector sizing based on varied fuel pressure values? Specifically, I am looking for data that correlates to 55 PSI base fuel pressure.
I've tried some of the published data on these injectors but the car ran terribly. Per the published data on ID1000s at 55 PSI base fuel pressure, the injector's size is 1135 cc/min with following offset values:
8 volts - 3015 microseconds
10 volts - 1815 "
12 volts - 1400 "
14 volts - 1055 "
16 volts - 820 "
Thanks in advance
ID1000 Injectors
FlashPro Manager software
Jump to
- General
- ↳ Hondata News
- ↳ Applications
- ↳ Non-Hondata
- s100/s200/s300
- ↳ s300 / SManager
- ↳ S300 Calibrations
- ↳ SManager Display Templates
- ↳ s100/s200
- ↳ Romeditor 4 Software
- ↳ HondaLogger Software
- ↳ Coil Pack Retrofit
- K-Series
- ↳ K-Pro / KManager
- ↳ K-Pro Calibrations
- ↳ KManager Display Templates
- ↳ K-Series Reflash
- FlashPro
- ↳ FlashPro Manager
- ↳ FlashPro Calibrations
- ↳ Accord 2008+ FlashPro
- ↳ Civic Si 2006-2011 Americas
- ↳ Civic Si 2012-2015 US/Canadian / 2013+ ILX
- ↳ Civic Type R 2006-2010 Japanese FD2
- ↳ Civic Type R 2007-2011 European FN2
- ↳ Civic Type R 2015+
- ↳ Civic 2016+ 1.5 Turbo Americas/Asia
- ↳ CRV 2017+
- ↳ CR-Z 2010-2012 US/Europe/Asia
- ↳ Fit 2007-2008
- ↳ RDX 2007-2012
- ↳ S2000 2006-2009 Americas/Europe/Asia
- ↳ TL 2007-2008
- ↳ TSX 2004-2014
- Traction Control
- ↳ General / Traction Control Manager Software
- ↳ Traction Control with S300
- ↳ Traction Control with KPro
- ↳ Traction Control with FlashPro
- Bluetooth Mobile Apps
- ↳ Hondata Mobile