Base target lambda overlay on WOT compensation tables

FlashPro Manager software
Post Reply
latelifecrisis
Posts: 13
Joined: Sat Dec 29, 2018 10:08 pm

Base target lambda overlay on WOT compensation tables

Post by latelifecrisis »

I am running Flashpro 3.4.4.0. I understand how the current WOT compensation tables work. I have WOT based on MAP table enabled so with Flashpro uses the low and high cam WOT tables when I exceed the specified MAP based on engine rpm.
I also understand the purpose of the target lambda overlay. Unfortunatley, this overlay is only based on engine load (MAP) without factoring in engine rpm.

What would be very helpful is to have the ability to have the target lambda overlay values (especially delta lambda) be based on the AFR values that are contained in the low and high cam WOT compensation tables. This would make the process of tuning the AFR values in the low and high cam fuel tables MUCH easier.

Is this a change that could be made to greatly simplify the fuel AFR tuning process whenever the WOT tables are used by the ECU?
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Base target lambda overlay on WOT compensation tables

Post by Hondata »

What vehicle? Why use an old version of the software?
Hondata
Post Reply