No Lift Shift Issue - 2014 Civic si FG4

FlashPro Manager software
Post Reply
chambers805
Posts: 18
Joined: Tue Dec 19, 2017 10:59 pm

No Lift Shift Issue - 2014 Civic si FG4

Post by chambers805 » Thu Jul 18, 2019 2:48 pm

Hello,

On top of the ethanol content timing table issue and the emissions codes for purge solenoid valve/gas cap issue. I'm also unable to set no-lift shift according to the documentation. It states it must be set 2000rpm under rev limiter, so my rev limiter is set to 7800 and I set no lift shift to activate at 5800 with more than 80% throttle. When I try to test his feature I keep hitting an artificial rev limiter at the 5800rpm mark. I can submit a log if needed, tested on production and beta same issue. Any update would be appreciated.

User avatar
Spunkster
Site Admin
Posts: 17932
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: No Lift Shift Issue - 2014 Civic si FG4

Post by Spunkster » Thu Jul 18, 2019 3:28 pm

Post the calibration as well as a datalog showing the issue.

chambers805
Posts: 18
Joined: Tue Dec 19, 2017 10:59 pm

Re: No Lift Shift Issue - 2014 Civic si FG4

Post by chambers805 » Thu Jul 18, 2019 9:28 pm

Here you go
Attachments
noliftshiftissue.fpcal
(22.22 KiB) Downloaded 16 times
Noliftshiftissue.fpdl
(768.86 KiB) Downloaded 17 times

User avatar
Spunkster
Site Admin
Posts: 17932
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: No Lift Shift Issue - 2014 Civic si FG4

Post by Spunkster » Fri Jul 19, 2019 9:10 am

I don't see anywhere in the Datalog where you are going wide open throttle and hitting any rev limit. I can also see it allowing you to rev to 7200 RPM. For no lift shifting to work you must keep the pedal all the way to the floor and only press the clutch and shift. When you press the clutch in it will rev limit to the 5800 and as soon as the clutch is released the RPM will return to where you were.

chambers805
Posts: 18
Joined: Tue Dec 19, 2017 10:59 pm

Re: No Lift Shift Issue - 2014 Civic si FG4

Post by chambers805 » Mon Jul 22, 2019 11:17 pm

Happens on the first pull in that log... its still early in the tuning phase from in this log, also I was only able to get past the RPM limit was when I downshifted through it. But i'll update with another log later, just super time consuming to replicate and not that big a deal. Rather get the Ethanol content timing tables working for 14+ si's first. XD

Post Reply