Flashpro won't connect to PC

FlashPro Manager software
Post Reply
cnordt24
Posts: 2
Joined: Fri Jun 15, 2018 8:15 am

Flashpro won't connect to PC

Post by cnordt24 » Fri Jun 15, 2018 8:26 am

I've been using the flashpro and flashpro manager for a while now and this is the first time I've seen this issue. I had a PC crash and I needed to reinstall the flashpro manager software. Now that it's installed, I plugged in the flashpro and it just blinks green. The manager shows a green check next to driver in the bottom left, but shows a red X next to flashpro. I pulled up the device manager on the PC and there is a yellow "!" on hondata flashpro, and I get an error "This device can not start Code10". I've tried reinstalling the manager and the USB drivers twice and I still get the same error. Any ideas or am I screwed??

Windows 10 software
Flashpro serial# FP-Fit-US-120053
Flashpro manager 3.0.8

User avatar
Hondata
Site Admin
Posts: 8811
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Flashpro won't connect to PC

Post by Hondata » Fri Jun 15, 2018 9:19 am

In brief: Open device manager, right click on the FlashPro, select update drivers, select manual install, select this directory C:\Program Files (x86)\FlashPro\Drivers
Hondata

cnordt24
Posts: 2
Joined: Fri Jun 15, 2018 8:15 am

Re: Flashpro won't connect to PC

Post by cnordt24 » Fri Jun 15, 2018 9:51 am

Thanks. I rebooted a few more times and finally got the pop up for the flashpro to update firmware. Once that updated it connected just fine, thank you!

Post Reply