Page 1 of 1

flashpro update,now rpm needle does't move while flashing why?

Posted: Tue Apr 24, 2018 3:51 pm
by boxer951
i updated my flashpro yesterday and now when i went to upload a calibration to my Fa5 civic,using the computer,it wouldn't allow me to.the upload button wasn't highlighted like it normally does,so it wouldn't allow me to upload.i then tried it without the laptop and it seemed to work but the rpm needle didn't move at all and it always used to,especially when uploading through only the flashpro.is it the new update?

updated on 4/23/18
i checked the bottom left screen on my laptop and it looked normal.had all green check marks.

Re: flashpro update,now rpm needle does't move while flashing why?

Posted: Tue Apr 24, 2018 4:38 pm
by Spunkster
Do you have a calibration open in the software when you are trying to upload?

Re: flashpro update,now rpm needle does't move while flashing why?

Posted: Thu Apr 26, 2018 2:45 am
by boxer951
yes.i had a calibration open and it still wouldn't work,which is why i had to try it out using only the fp without the laptop.

Re: flashpro update,now rpm needle does't move while flashing why?

Posted: Thu Apr 26, 2018 9:21 am
by Spunkster
From Help, About, what is the version of software you are using?