Active Fuel Tuning (MAP)
Posted: Fri Jan 05, 2018 11:31 am
FlashPro Manager version: 2.8.6
2006 Civic Si, slighty modified
Issue:
When trying to use "Active Fuel Tuning" (i.e. using MAP), I can't seem to download the changes the ECU is making into the calibration.
From a new calibration, these are the steps I've done:
Fuel > Uncheck "AFM Enabled", check "Use speed/density (map) fuel tables"
Fuel > Active Tuning > check "Active Fuel Tuning enabled"
Upload calibration to ECU.
Drive around for roughly 30 minutes.
Turn the car fully off.
Turn the ingition to the "ON" position.
Note: The second time I attempted this, I left the laptop on and flashpro plugged in.
Now here's where I get confused.
When I click "Download Active Tables from ECU" in either "Active Fuel Tuning Low" or "High" table, nothing gets updated. Everything (the Trim%) stays at 0.00. I've also tried "Merge active table into main tables" but there was also no difference in the adjustments.
What am I doing wrong?
Can someone list the proper way to use Active Fuel Tuning?
I've done Active AFM tuning (in Sensors > AFM > Active Fuel Tuning enabled) and after driving around for a short period of time, clicking "update Active Tuning Table" actually updated and changed flow values. I wanted to switch over to MAP and thought it would be as easy but it seems to be eluding me.
Thanks.
2006 Civic Si, slighty modified
Issue:
When trying to use "Active Fuel Tuning" (i.e. using MAP), I can't seem to download the changes the ECU is making into the calibration.
From a new calibration, these are the steps I've done:
Fuel > Uncheck "AFM Enabled", check "Use speed/density (map) fuel tables"
Fuel > Active Tuning > check "Active Fuel Tuning enabled"
Upload calibration to ECU.
Drive around for roughly 30 minutes.
Turn the car fully off.
Turn the ingition to the "ON" position.
Note: The second time I attempted this, I left the laptop on and flashpro plugged in.
Now here's where I get confused.
When I click "Download Active Tables from ECU" in either "Active Fuel Tuning Low" or "High" table, nothing gets updated. Everything (the Trim%) stays at 0.00. I've also tried "Merge active table into main tables" but there was also no difference in the adjustments.
What am I doing wrong?
Can someone list the proper way to use Active Fuel Tuning?
I've done Active AFM tuning (in Sensors > AFM > Active Fuel Tuning enabled) and after driving around for a short period of time, clicking "update Active Tuning Table" actually updated and changed flow values. I wanted to switch over to MAP and thought it would be as easy but it seems to be eluding me.
Thanks.