Question on locking the hondata to ECU?
Question on locking the hondata to ECU?
I have an order for the FlashPro 2007 TSX unit and have been reading everything I can on the matter. One thing worries me and I wish to confirm if I should be worried. I do not have a laptop at all and have no access to one. Can, I complete locking the hondata to my ECU in trips from the car back to pc?
Re: Question on locking the hondata to ECU?
Yes.
1. Install the software on a PC. Plug in the FlashPro, fill out the registration details and register with Hondata.
2. Take the FlashPro to the vehicle, plug it in, switch on the ignition for 5 seconds or so (but don't start the car). This records the VIN.
3. Take the FlashPro to the PC, plug it in. Select Online, Lock.
4. Select a calibration, upload to the FlashPro.
5. Go to the vehicle, plug the FlashPro in, switch on the ignition. Press the Program button on the FlashPro for over 1 second.
6. The program light should start to flash after about 15 seconds, then stop flashing once the ECU is programmed (about 90 seconds).
1. Install the software on a PC. Plug in the FlashPro, fill out the registration details and register with Hondata.
2. Take the FlashPro to the vehicle, plug it in, switch on the ignition for 5 seconds or so (but don't start the car). This records the VIN.
3. Take the FlashPro to the PC, plug it in. Select Online, Lock.
4. Select a calibration, upload to the FlashPro.
5. Go to the vehicle, plug the FlashPro in, switch on the ignition. Press the Program button on the FlashPro for over 1 second.
6. The program light should start to flash after about 15 seconds, then stop flashing once the ECU is programmed (about 90 seconds).
Hondata
Re: Question on locking the hondata to ECU?
Thank you for the quick reply and making the unit for my make and model.Hondata wrote:Yes.
1. Install the software on a PC. Plug in the FlashPro, fill out the registration details and register with Hondata.
2. Take the FlashPro to the vehicle, plug it in, switch on the ignition for 5 seconds or so (but don't start the car). This records the VIN.
3. Take the FlashPro to the PC, plug it in. Select Online, Lock.
4. Select a calibration, upload to the FlashPro.
5. Go to the vehicle, plug the FlashPro in, switch on the ignition. Press the Program button on the FlashPro for over 1 second.
6. The program light should start to flash after about 15 seconds, then stop flashing once the ECU is programmed (about 90 seconds).