Page 1 of 1

Greddy Turbo cal question

Posted: Tue Jul 28, 2009 2:50 pm
by ImAuthenticFTW
When you guys made the turbo calibrations, where did you have the MAF/IAT put? on the original spot before the turbo or did you relocate it post intercooler before the TB?

Posted: Tue Jul 28, 2009 3:42 pm
by Hondata
In the stock location.

Posted: Wed Jul 29, 2009 10:02 am
by ImAuthenticFTW
meaning after the intercooler but before the throttle body right?? because the Greddy kit has you put it on the intake to the turbo which was very stupid IMHO

Posted: Wed Jul 29, 2009 10:46 am
by Hondata
Before the turbo. Yes, this is not a good place to measure the air temperature for forced induction. Also, if a blow off valve is used then there is an unmetered air loss from the system and the AF will be too rich when the blow off operates.

Posted: Thu Jul 30, 2009 6:45 am
by ImAuthenticFTW
i understand all of that, but when you guys did the calibration for the 370, 650 etc etc injectors, where did you locate the IAT sensor?

Posted: Thu Jul 30, 2009 7:54 am
by Hondata
In the stock location, before the turbo.