FlashPro annoucement
Posted: Fri May 08, 2009 12:47 pm
We will try to answer any additional questions on the product page or in this forum.
See http://www.hondata.com/flashpro.html
See http://www.hondata.com/flashpro.html
and doing this will allow my 64-bit laptop to run the drivers needed?? that would be awsome, how exactly is this done lolHondata wrote:You can always boot the laptop into 'use unsigned drivers' mode.
Don't understand. If you have a 08 Si and are using a K20Z3 engine, what has been swapped? Why does the ECU need to be changed?Karim wrote:First thank you guys for the Flashpro
I have a couple of questions for you guys
I have an 08 Si and also purchased a K20z3 that is beeing fully built by Endyn and the corresponding ECU and gauge cluster. My question to you is as i make the swap can i use the current ECU or do i have to use the donner ECU and will i have problems with the immobilizer? I know it's a bit ahead of time to talk about this but i am curious none the less.
Press F8 when booting and select 'disable driver certification enforcement'. I believe that you can set an option to do this automatically every boot. Do a search for DDISABLE_INTEGRITY_CHECKS.ImAuthenticFTW wrote:and doing this will allow my 64-bit laptop to run the drivers needed?? that would be awsome, how exactly is this done lolHondata wrote:You can always boot the laptop into 'use unsigned drivers' mode.
Yes. No. Only 1 ECU at a time.dcloo wrote:some question
does the software work under win xp
the flash pro work on auto transmission
can it be tune more then 1 ecu/car
yea man im not even gettin your build, your swapping in a K20Z3, but you do know that is what comes in the car right?? so it should use the same ECU anywayKarim wrote:First thank you guys for the Flashpro
I have a couple of questions for you guys
I have an 08 Si and also purchased a K20z3 that is beeing fully built by Endyn and the corresponding ECU and gauge cluster. My question to you is as i make the swap can i use the current ECU or do i have to use the donner ECU and will i have problems with the immobilizer? I know it's a bit ahead of time to talk about this but i am curious none the less.
1. So does that mean 1 unit Hondata flashpro can only work with one ecu or car only? Which mean i can't buy one set flashpro and used it together with a few of my buddies civics?Hondata wrote:Yes. No. Only 1 ECU at a time.dcloo wrote:some question
does the software work under win xp
the flash pro work on auto transmission
can it be tune more then 1 ecu/car