E85 cold start in new york
E85 cold start in new york
Hi just wondering how can I adjust my map to turn the car on cold start. It’s 30 degrees here in New York and my si is a built motor. K24a2 block 12.5 bc rods supertech springs and retainers and valves skunk2 ultra 4 cams. Full ported Xsseive side feed ktuned 72mm 4” cai id 1000cc injectors. Walbro 255 on e85.
- Attachments
-
- 83E271EF-1558-422D-A626-0BEF0BFA8F97.jpeg (981.52 KiB) Viewed 2631 times
Re: E85 cold start in new york
Have you discussed this with your tuner?
You may have to reduce the amount of ethanol in cold weather.
You may have to reduce the amount of ethanol in cold weather.
Re: E85 cold start in new york
I tried calling my tuner but no answer. How can I reduce the amount of ethanol?
Re: E85 cold start in new york
put less ethanol in the tank
Re: E85 cold start in new york
Look at the Calibration -> Ethanol -> Ethanol ECT cranking table and either post the calibration or tell us what is in it.
Hondata
Re: E85 cold start in new york
i think i figured it out. in the cranking fuel trim table, the 1st column from 0 rpm - 2000 rpm i raised it by 15% and the car started.
- Attachments
-
- IMG_0252.jpg (4.19 MiB) Viewed 2617 times
-
- IMG_0253.jpg (3.52 MiB) Viewed 2617 times