2009 Civic Si K20/24 Frank Basemap

FlashPro questions & answers specific to the 2006-2011 Americas Civic Si
Post Reply
XeroTech82
Posts: 4
Joined: Fri Feb 14, 2020 4:18 pm

2009 Civic Si K20/24 Frank Basemap

Post by XeroTech82 »

Hey guys, I need a basemap to get my new build up and running.

-2009 Civic Si
-2008 Acura TSX (K24a2) bottom block with the 09 Si (K20z3) Cylinder head and accessories.
-Using the TSX camshafts with the stock VTC Wheels
-NST Lightweight Pulleys
-K-Tuned Oil Pan
-RSX Oil Pump
-I also moved over the K20z3 oil cooler with the water pump.
-Stock TB and RBC Intake Manifold
-Stock fuel injectors and pump
-93 Octane
-K-tuned Racing Header w/ pipe and 3-inch Exhaust
-We’ll go ahead with 8000 rev limit for now, If I feel it’s not enough I’ll pump it up to 8500
-K-Tuned SRI and CAI (it's easy to swap between the 2)

My question is, since the SRI and CAI can transform so easily, do I need 2 separate maps for when I switch them? Or will a single map be able to fully utilize both setups? If it’s the former, if I could get a basemap for both setups, that would be fantastic.
FA508
Posts: 6
Joined: Sat Aug 29, 2020 10:59 am

Re: 2009 Civic Si K20/24 Frank Basemap

Post by FA508 »

What calibration or basemap are you using from flash pro to run now? Since you have k24/k20, short ram intake or cold air intake, race header and full catback exhaust? Maybe someone here with the same or similar setup can help otherwise since you have everything completed full bolt on then get it tune by a professional. Once you are tune with your setup you car will runs good and with instant gain of power. Maybe low13 second to high 13 second quarter mile.
Post Reply