Closed loop parameter settings

FlashPro questions & answers specific to the 2006-2011 Americas Civic Si
Post Reply
K20remix
Posts: 20
Joined: Wed Oct 24, 2018 10:22 am

Closed loop parameter settings

Post by K20remix »

Hi , nice to join in the forum and I'm new to Hondata flaspro which it is current running on my k20 engine.

Just would like to understand more on Hondata which I am unclear in the closed loop setting.

Hope I can get guidance from all the pro here.

My setting current is using by default TPS WOT, but not Map Determination for WOT.

Can all the pro advice me that, (question refer to the picture numbering)

1. Is the closed loop target defines minium target lambda value?

2. Is the closed loop target lambda limit define maximum of the lambda value over ECT?

3. Is this define the target lambda target under low load? What is the low load? what is the low load refering to?

4. Is this define the target lambda target under high load? What is the high load? what is the low load refering to?
Attachments
IMG_20181025_013332.jpg
IMG_20181025_013332.jpg (108.66 KiB) Viewed 2491 times
User avatar
Spunkster
Site Admin
Posts: 22740
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Closed loop parameter settings

Post by Spunkster »

1 is not a limit, it is the target value
2 is the limit for that ECT value

Have you read the help file at: https://www.hondata.com/help/flashpro/c ... sub=lambda
K20remix
Posts: 20
Joined: Wed Oct 24, 2018 10:22 am

Re: Closed loop parameter settings

Post by K20remix »

Understood.

If say the target value was set at 14.30, does this mean that the ecu will control F.trim not lesser or highet than 14.30?

And if the ECT was set 14.6 at 80 degree C, does that mean that any temp on 80 or above, the ecu will control AFR not above or lower 14.6?

Thanks for the guidance
K20remix
Posts: 20
Joined: Wed Oct 24, 2018 10:22 am

Re: Closed loop parameter settings

Post by K20remix »

After reading your reply, I have created a table as the image attached.

I set slight leaner cruising from the value 14.3 got from my wideband .

Refer to my image, I would likw to know am I correct?

Hope to have guidance and thanks alot
Attachments
My setting for lean cruising
My setting for lean cruising
IMG_20181025_204430.jpg (4.88 MiB) Viewed 2472 times
User avatar
Spunkster
Site Admin
Posts: 22740
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Closed loop parameter settings

Post by Spunkster »

Fuel trim is separate form the target. The fuel trim will be adjusted to meet the target.

Any temp higher than that will target the last value in the table.
Post Reply