MAP

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
Bones126
Posts: 16
Joined: Thu Oct 04, 2018 2:09 am

MAP

Post by Bones126 »

Hi, sorry for novice question. But can I take this is a MAP tune an not MAF, so the AFM is redundant apart from the IAT sensor?
Attachments
03BAE993-2EFB-446A-9315-756652779441.jpeg
03BAE993-2EFB-446A-9315-756652779441.jpeg (1.89 MiB) Viewed 406 times

EFICU
Posts: 138
Joined: Mon Feb 25, 2019 10:14 pm

Re: MAP

Post by EFICU »

Having the boxes checked the way they are in your photo will make it run on the MAP sensor and the MAF would essentially be an IAT sensor.
EFI Calibrations Unlimited

Bones126
Posts: 16
Joined: Thu Oct 04, 2018 2:09 am

Re: MAP

Post by Bones126 »

Excellent, thank you @EFICU for the reply. Much appreciated.
I can now look at re-locating the IAT to after the supercharger for a better reading.

Thank you again.

EFICU
Posts: 138
Joined: Mon Feb 25, 2019 10:14 pm

Re: MAP

Post by EFICU »

No problem. You definitely want the sensor after the supercharger for a proper reading.

Are you running any type of intercooler or aftercooler in the system? If so, you might want to see if you an incorporate and IAT and an IAT2 sensor into the system. Then you can see the cooling efficiency of the intercooler/aftercooler by monitoring the temps going into the supercharger and how much cooler they are entering the engine. I don't have any experience with running such a setup, but other people can maybe chime in. If you're not running any intercooler/aftercooler they may not be any real benefit to knowing the before and after temps.

Good luck with it!
EFI Calibrations Unlimited

Bones126
Posts: 16
Joined: Thu Oct 04, 2018 2:09 am

Re: MAP

Post by Bones126 »

EFICU wrote:
Wed Oct 23, 2019 12:34 am
No problem. You definitely want the sensor after the supercharger for a proper reading.

Are you running any type of intercooler or aftercooler in the system?

Good luck with it!
Yeah, running an Intercooler (after charger before plenum/manifold). Will definitively be relocating the IAT to the pipe from the intercooler to the plenum/manifold (TTS set up).
I'll look into the IAT2 set up though, as you say, will be interesting to see how effective the FMIC is.

Will look like this eventually;
Slepy 1.jpg
Slepy 1.jpg (329.62 KiB) Viewed 378 times
Thank you again for the help and suggestions, big help, much appreciated.

EFICU
Posts: 138
Joined: Mon Feb 25, 2019 10:14 pm

Re: MAP

Post by EFICU »

Looks like it will be a fun setup. Good luck with it.

You're welcome!
EFI Calibrations Unlimited

Post Reply